So You Want To Intramuscularly Administer 5-MeO-DMT HCl (or other salt)
by HumbleVoyager
Disclaimer: This information does not condone the activity it describes. Anything attempted is at one's own risk and knowledge that there are serious consequences if anything goes wrong in this process. Risks include, but are not limited to, infection, abscess, psychosis and injuries. This information is provided to help prevent problems that might arise if someone attempted this without appropriate information. Please PROCEED AT YOUR OWN RISK.
Materials Required:
-1 vial of sterile saline solution 20ml is a good size.
-Sterile 20ml syringe.
-Any number of single-use, brand-new syringes. I suggest using 1cc (1 ml) 27 gauge, 1/2 inch needles. 1 inch needles if you have a lot of fat in your thigh.
-Empty sterile vial with rubber membrane on top
-Micron filters.
NOTE: If you get these, you will also need to buy some luer-lock needles to go with them unless the other syringes you buy come with removable needles.
-Cotton balls
-Rubbing alcohol (isopropyl alcohol)
1. Acquire 5-MeO-DMT in a salted form.
2. Make a calculation as to how you'd like to dose. I'd say that 10mg/ml is a good concentration. That way if you wanted to dose 5mg, you'd draw up .5cc's in your syringe. When you do an intramuscular injection, you really want as little fluid in there as possible.
3. Get one of your 20ml syringes, affix a needle onto the end, and remove the plunger. Into the barrel of the syringe, place the total amount of 5-MeO-DMT HCl (in this case you would be putting 200mg 5-MeO-DMT HCl). Then put the plunger back into the syringe, but don't push it down yet. Keep it at the top of the barrel.
4. Get your vial of sterile saline solution. Insert the needle and push the plunger down so that the vial gets filled with air. This will keep a vacuum from forming when removing the saline solution. Be careful to not go so far as to push any of the 5-MeO-DMT into the vial.
5. Begin pulling the syringe back and draw up 20ml or 20cc's of saline solution into the syringe. Make sure it fills up completely. If there are air bubbles, take the syringe out of the vial of saline and get the air out to ensure that you have a full 20cc's in there.
6. Shake that syringe until the 5-MeO-DMT HCl has completely dissolved. It should just look like clear water when it is completely dissolved.
7. Hold the syringe with the needle facing up. Cap and remove the needle. Set it aside.
8. Screw on the micron filter and then screw on the needle to the output port of the filter.
9. Insert the needle into your sterile, empty vial and depress the plunger. This will be a bit difficult to do and will require some strength. Be patient and let it go at its own pace. [OPTIONAL: You can also insert a second needle into the top of the vial to act as a vent to equalize the pressure. This will make it easier to inject the filtered solution into the vial.]
10. Now your vial contains a sterile, filtered solution ready for injections. Label the vial with the substance it contains AND THE CONCENTRATION. For example, this vial would read: 5-MeO-DMT HCl - 10mg/ml
11. Note: ALWAYS use a NEW NEEDLE. NEVER REUSE NEEDLES. You don't want to contaminate the sterile environment in that vial.
12. Now it's time to dose yourself. First, set up a clean, safe environment. Sterilize any surfaces you will be keeping your vial, syringes, cotton balls, and rubbing alcohol. I have used a brand new cookie sheet for this purpose and have rubbed the whole thing down with rubbing alcohol to kill any bacteria. Set up any playlist you'd like for the experience at this point.
13. Wash your hands THOROUGHLY. You don't want any bacteria getting anywhere near the inside of your muscle.
14. This is best done with shorts of some kind or naked, because you will need access to your thigh. You can also inject into your deltoid muscle but that just tends to be more painful and is hard to do to yourself. I will just talk about injecting into the thigh.
15. Take a good look at your thigh. You will want to divide it into four equal quadrants. Your injection should happen in the bottom-right quadrant for your right thigh or the bottom-left quadrant for your left thigh. If necessary, draw the quadrant lines.
16. Once you have determined where your injection site will be, wet a cotton ball with rubbing alcohol and sterilize the thigh by rubbing it in an outward spiral motion, from the injection site outward. Take your time and make sure you don't miss a spot.
17. Let the rubbing alcohol dry.
18. Draw up your dose from your vial. Remember to double-check your dose as you do this to make sure you have the correct amount.
19. Hold the syringe in one hand like a dart. With your free hand, spread the skin on your thigh apart so it's tight. This will eliminate or at least significantly minimize any pain when you insert the needle.
20. Insert the needle at a 90 degree angle to your skin. You want to do this in one continuous motion, it doesn't have to be fast. Once it's in, I would suggest not letting the syringe move around so much. You can let go of the skin that is stretched now that the needle is in place and use it to steady the syringe.
21. Pull back on the plunger slightly to make sure you haven't hit any veins or arteries.
22. If there is NO blood registering in the barrel, you are good to go. Inject slowly and steadily. If you feel any pain or severe stinging, slow down your rate of injection. Breathe deeply as you do this. Sometimes people hold their breath.
23. Once you are done injecting, try to cap your needle and put it on your tray or somewhere that it won't be stepped on or otherwise messed with.
24. Lay down and dream with Love.
I hope this guide is helpful to anyone who wishes to take this sacrament in such a manner.
Love and Blessings.
